Overview:

The Matek Digital airspeed sensor (UAVCAN/DLVR version) is designed specifically around ArduPilot and their flight controllers supporting UAVCAN bus such as the H743 Wing. Matek also sell a more simpler version for use with INAV, see other items.

Please see the Matek website for details on how to configure http://www.mateksys.com/?portfolio=aspd-dlvr#tab-id-2

Specifications:

– ArduPilot AP_Periph F303 CAN node
– All sensors DLVR-L10D, Industrial temperature range
– CAN & I2C Interface
– Typical Platforms: Fixed-Wing, QuadPlane, VTOL
– CAN JST-GH connector, UAVCAN Protocol
– I2C JST-GH connector, DLVR-L10D I2C mode (I2C address 0x28)
– UART1, Firmware update
– UART2, Spare for external GPS
– UART3, MSP Protocol (To be supported)
– CAN bootloader LED, Blue
– Fast blinking, No communication between CAN node and Flight Controllers
– Slow blinking, Communicating between CAN node and Flight Controllers
– 3.3V Power LED, Red
– Input voltage range: 4~6V
– Power consumption: 60mA
– Operating Temperatures: -20°C to 85°C
– Pressure Range: 2500Pa (± 10 inH2O)
– Burst Pressure: 75kPa
– Speed Range: ±250 km/h
– 22mm*22mm*12.5mm
– 4g

Included:

– Matek Digital Airspeed Sensor ASPD-DLVR
– 2x JST-GH-4P to JST-GH-4P 20cm silicon wire